57 pts ยท December 22, 2015
thanks. one of my best pieces I've made so far
honestly better to use cubic zirconia. much much cheaper, completely indistinguishable to 99% of people, just make sure the customer knows
2/2 the sil-phos copper brazing rod melts at about 1200*F (649*C) so a standard soldering iron for electronics won't even come close
the wire frame was done with a cheap butane torch from harbor freight, to get the sheet onto the back I had to use a blow torch for heat los
SERIOUSLY! MEASURE TWICE CUT ONCE!!! AND TAKE THE KERF INTO CONSIDERATION!
I do blacksmithing and other metalwork since I'm getting my degree in sculpture at university. I have some other stuff to post
thanks. one of my best pieces I've made so far
honestly better to use cubic zirconia. much much cheaper, completely indistinguishable to 99% of people, just make sure the customer knows
2/2 the sil-phos copper brazing rod melts at about 1200*F (649*C) so a standard soldering iron for electronics won't even come close
the wire frame was done with a cheap butane torch from harbor freight, to get the sheet onto the back I had to use a blow torch for heat los
SERIOUSLY! MEASURE TWICE CUT ONCE!!! AND TAKE THE KERF INTO CONSIDERATION!
I do blacksmithing and other metalwork since I'm getting my degree in sculpture at university. I have some other stuff to post